Posted on

how to tell if a weed seed is dead

The first stages of growth survived with success!

The same can happen in other germination media such as jiffy plugs, where the most common mistake is usually not draining away the excess water after re-hydrating the compressed peat. To this error, we can add that of burying the seed at more than twice its own depth, in which case it may not emerge despite having germinated perfectly well, but instead, simply end up rotting due to excess water and lack of oxygen. This error is also frequent in growers who germinate directly in the soil because when they first irrigate, the seed can be washed down into the soil resulting in them being buried too deeply, which makes it difficult for the seedling to reach the surface. It is always better to wet the substrate first, before sowing any seeds.

The proper conditions guarantee good germinación

Seeds dying due to lack of moisture

The same goes for unopened whole packs of seeds that have been purchased to store for later use. Sometimes, certain varieties are in high demand and there is limited stock, so the more astute growers will make sure they grab a few packs to keep in the vault until they find the time to germinate the cannabis seeds.

It is often said that you must irrigate with an appropriate amount of water and nutrients for the size of the plant. As this is often complicated to carry out, as a rough guide we can irrigate the plants with an amount not more than 10 or 20% of the plant pot’s capacity. So, if they are 1L pots we will water from 100 to 200ml as long as it is not an auto-flowering plant.

If it is winter, the plates holding the seeds are often placed on top of a low heat source to raise the temperature. We must, however, be careful: if this heat source emits hot air, the paper towels will dry out and the seeds will run out of moisture, affecting germination. If you realise this in time, you can re-hydrate the seeds and they will usually recover from and continue to germinate, although it is also possible that there will be consequences that may affect the subsequent development of the plant during its cultivation.

The reason for this is that tap water contains chlorine, which sterilises the water to make it suitable for domestic use. However, this chlorine disappears by evaporation after a few hours, so if the water then gets contaminated, the seed can be attacked by any number of pathogens and eventually die. This example also illustrates why we must always touch the seeds with clean hands; If the seeds are handled with dirty fingers, it can lead a fungal or bacterial infection to contaminate them and severely compromise their development.

Note: Only do this if you’re ready to germinate your plants. Otherwise, it could harm your seed. I cover germination in a later section.

You can tell a lot about a seed’s health just by looking at it. Here are a few different things you should look for when deciding if a cannabis seed is good or not.

Test Method #1: Floating Seeds in Water

Got a cannabis seed, but you’re not sure if it’s any good? No worries. By the end of this article you’ll know everything you need to get started.

Another way is to put the seeds on a damp paper towel. Make sure the paper towel is damp, but not soaking wet. If it dries out you can add a few drops of water to the paper towel. Leave the paper towel in a dark place. The amount of time is going to vary among strains. Some may take only 2 days while others could take longer. Continue to check them once a day.

Now that I’ve gone over a basic guide for what to look for I’ll give you a couple of ways that you can test your seeds.