Some cannabis growers may fill the cup about halfway before planting the young seedling. Adding more can be beneficial for the root system. Continue putting soil in the pot until you reach about 1 cm below the edge of the container. You can press the growing medium down lightly, but do not compact it. When you have the amount you need, you can move to the next step.
The next step of planting a cannabis seed is to move it into a small hole. Gently pick up the plant and place it into the soil. Some growers prefer to use a clean pair of tweezers to transfer it over to the pot. It is critical not to squeeze too hard to prevent the germinated seed from getting hurt. Make sure to plant quickly to ensure the budding roots stay safe from excessive light.
Step 1 — Fill a Pot or Cup With Potting Soil
After you are done filling the pot with soil, make a small hole for the germinated cannabis seed. Since the seedling is tiny, a clean pen or pencil can make the dimple the appropriate size. Place the writing tool on top of the soil and push it down to create the dimple. The depth of a hole matters for the growth of a weed seed.
Once you have the best pot or cup for your germinated seed, fill it with soil. After planting is done, the root system should always grow downward as the plant gets bigger. Therefore, you do not want to put in too little. The roots still need enough space to absorb nutrients.
Burying a weed seed too far into the soil can negatively impact its growth. The recommended depth of the hole is 2 to 2.5 centimeters. It is the best length because seedlings have roots that are 1.5 to 2.5 centimeters long. A couple of centimeters ensures they have enough space.
Dig a small hole in your bigger pot for the seedling, and place the mykos rooting pack in the bottom of the hole. Then carefully dislodge your seedling along with its seedling pellet. The best way is to invert the germination cup and tap on the bottom, being careful to hold any soil from falling out with your hand.
Our favorite thing about starting from a seed, rather than a clone, is that you get to see the full life cycle and enjoy a plant that is unique, just like you. An entirely new genetic makeup will enter the world for the first time, and if you’re lucky, something remarkable might be born.
The first set of leaves to come above ground are called the cotyledons. These little leaves are packed with energy and will grow to about 1/4 in in size before eventually falling off. Your second leaves to emerge will be single blades and look like regular pot leaves.
4) Lighting for your seedling
We hope this guide helps you find fun and success with your plant. If you have any questions, please comment below. Check out our kits here if you’re ready to get started.
To accelerate germination, you are going to want to soak your seed in a small container with lukewarm water and place it in a dark and warm place for 12-24 hours, but no longer. By drenching the seed, it absorbs the water thoroughly, activating the germination process. Doing this also helps to loosen the shell as it becomes a little softer making it easier for the embryo to crack it open. When your seed sinks to the bottom it is ready to be planted, and sometimes the seed will pop out a small taproot. A seed can still be planted though if it does not sink.
When the plant has hardened off, roots will start emerging from the bottom of your seedling pellet and the plant is ready to be transplanted into a bigger pot. Be very careful not to damage the roots during this stage. Any stress will slow its growth.
Dampening off happens when the seedling is in too moist of an environment. The stem starts to rot at the bottom. When this happens, the plant will bend over and die if not treated. To help fight the infection, lightly spray a 0.5% solution of hydrogen peroxide around the affected area.