Posted on

how to grow a weed plant from a seed

Johnson notes that the outdoor grow season lasts from around April to October, meaning if you plant seeds now, they’d still yield flower, but not much. Since it’s late in the season, he suggests buying a large clone, which will have more branches and therefore yield more flower.

If you buy seeds from a seed bank, look for those labeled “feminized” to ensure they give rise to female plants, Johnson says. But if you’re a total newbie, he suggests buying clones, which are cuttings from a “mother” female plant, available at some dispensaries, as well as at nurseries. Not only are they easier to obtain, “they’re easier to grow. You get a clone, and you transplant it to some soil.”

Planting

Since clones come from plants that have been grown indoors, let yours chill in a shaded area for a week before exposing them to full sun, Johnson says. “The clone hasn’t tasted sun like that, and the transplant itself will be stressful.”

That said, when your plants are fully flowering, you might find yourself watering them daily, based on these indicators. When you do water them, keep going until you see water running off the soil, to ensure the water reaches all of the soil in the pot.

Do your homework and read up on the laws in your state. Some states prohibit growing cannabis, while others, like my home state of California, permits anyone over age 21 to grow cannabis, but only up to a certain number of plants. NORML has a pretty in-depth guide to the laws in each state. Colorado, Oregon, Nevada, Vermont, and Maine also allow cultivation, but again, the specifics depend on the state. Definitely clarify what your rights are before you start the glorious path to at-home bud gardening.

Now bury it on top of the rooting pack so the base of its stalk is level with the top soil. Give it a proper watering to set the roots in the ground, then skip your next watering so the roots can take hold.

They will become several inches in length. During their growth your first actual set of leaves will appear. These are typically three blades. Around this time is when your plant is “hardening off”. You will notice that the stem will start to develop a thicker skin and harden off. As the leaves of the plant get bigger, they can gradually handle more sunlight, so move it into more direct light.

Perhaps the most exciting stage, your baby will typically come above ground in 1-2 weeks. As your seedling comes above the soil, its shell might take a few days to fall off. It’s best to leave it alone, nature has the job covered. If it does not come above ground after about two weeks, the chance of success is dramatically reduced, and it’s best to try again. Even the best seeds have an 85% germination rate. When your seedling comes above ground, it is going to want to see a direct light source.

4) Lighting for your seedling

For young plants, it’s best to use bottled water as it has no chlorine added. If using tap water, let it sit for 24 hours before watering to dissipate any chlorine. Chlorine can also be eliminated by boiling for 20 minutes. Under normal conditions, after soaking your seedling pellet, it should contain all the moisture your plant needs before it comes above ground. As it grows, it will only need about a shot glass worth of water at most per week to keep the medium damp. Seedlings don’t drink a lot of water, which makes sense given their size. Your plant will do better in a growing medium which is damp. Overwatering is just as deadly as drying out.

Seedlings require a medium amount of light in which it has enough to grow but not too much light that it gets burned. Leaving your seedling in direct sunlight will cause the leaves to curl, while too little light will cause the seedling to stretch. If growing outside, seedlings want to see a direct light source to stop them stretching. If inside, a sunny windowsill with more than half a day of sunlight works wonders. Otherwise, 18 in away from a growing light works excellently. Your seedling should not stretch more than 6 in at most. We’ll cover lighting in more depth in a later blog.

Cultivating marijuana plants from a seed rather than a clone can be quite exhausting since it requires a lot of care for the plants to germinate. There are some good practices that you should undertake before planting a seed to ensure maximum germination. First, you should start by soaking your seeds in container containing lukewarm water in a dark environment for 12-24 hours. Soaking the seeds accelerates germination by softening the outer shell. During planting, use seedling pallets soaked in water for 10 minutes. Place the seeds in a small hole ¼ in deep and then gently cover with dirt from the pallet.

We hope this guide helps you find fun and success with your plant. If you have any questions, please comment below. Check out our kits here if you’re ready to get started.